Eotech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUM Manual de usuario descargar pdf (Pagina 58)

3-8

3.3 CORRECTIVE MAINTENANCE (Continued)

Replacing Aim Neutral Density / Opaque Lens Cap or

Pattern Generator

1. If applicable, pull both retaining straps off the Lens Cap

attachment points. Attachment points are located on both

the top and bottom sides of the ATPIAL housing.

Figure 3-4. Lens Cap Attachment Points.

2. Examine the replacement lens cap. Note that one side is

flat and the other side is contoured. Also note that one of

the filters is glossy (Neutral Density) while the other is dull

(opaque).

3. Ensuring the flat side of the new lens cap will face out,

position the lens cap over the Aim Lasers as shown in

Figure 3-5. The glossy, Neutral Density filter must be

aligned with the IR Aim Laser.

ATTACHMENT

POINTS

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 69 70

Sin comentarios

Eotech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUM Manual de usuario Pagina 58